How to draw a table with a pencil step by step

How to draw a table with a pencil step by step

1. How to draw a table for beginners simply.

Draw two parallel straight lines of identical length, one is slightly more to the right another, then connect the ends of these straight lines. We lower strictly down straight lines of equal length.

We set thickness of legs, the most extreme right leg of a table, not such as previous, it very thin and connection goes on a diagonal, parallel to the party. In the same way we will add the second side of legs (a leg square, but only two parties are visible to us) for all legs, except the most right from above, there we draw as drew the others in point 4. We draw partitions, then a table cover (the cover at us sticks out for the basis, has small height, all lines are also parallel). We erase unnecessary lines and a table it is ready.

2. How to draw a table, using prospect.

In this option the knowledge of bases of prospect is necessary. If you are not familiar, surely see a lesson "Prospect bases in drawing ". The first option of a table was simple, to be under construction without prospect, but this is not present, we need prospect. For this purpose we will draw the horizontal line of the horizon. We have two points of a descent And and In, but the table very close is to a point And therefore we on our leaf will not be able to show a point V. Risuyem two any beams, then approximately at an angle we draw width of a table, lines seem to us are parallel, but they absolutely are a little not parallel because all of them equally somewhere will meet in a point of a descent of V. Ubedites that the prospect correct that the nearest corner has to be stupid, i.e. is more than 90 degrees. We have it stupid.

Here it is visually possible to look received figures, but so far erase nothing.

Drawing of the following stage, with prospect below. From the nearest corner we lower a straight line down, we measure length by eye. Now let's pass to the following drawing. We do not draw table-top height yet, we pass.

Now we connect a point And and the end of our leg, then we lower from the most left corner a straight line down to crossing with only that the drawn line. It will also be height these are legs. Remember and that a point In very far and at present table top straight lines slightly, very much, are almost imperceptibly not parallel. From the first leg we carry out part of the line which had to go to a point V. Teper it is lowered from the bottom right corner a straight line before crossing down to the line which was just drawn, and from this point we draw a straight line to a descent point A. Potom from the last corner we lower a straight line to this line.

We give to legs of a table of volume, having drawn the additional parties and we connect a crossbeam them. We draw table-top height.

Here so it looks in creation of prospect. You will need to carry out direct Q. The principle same, we measure leg side width by eye, from the end carries out to a point And. Crossing of a straight line of Q and this straight line K. Teper also with other leg gives a point, suppression gives a point of L. To draw a table-top, we too need to draw beams.

This table drawing.

2. We draw a cloth on a table. To draw a cloth, we also draw a table, it will only not be necessary to draw a crossbeam, width of the top part and the most distant leg. We draw here such lines.

We erase, all that is not necessary and drawing of a table with a cloth is ready.

3. Table side view.

We draw a cover of a table and two legs on each side.

We again will need creation of lines of prospect, it is possible and approximately. The line of the horizon — it at us the line of top of a table, a point of a descent will be at us one and is directly on the middle. We need to draw from a point of a descent straight lines to final points of legs of a table. We measure an arrangement of distant legs by eye (than the table will be longer, legs will be closer to those to the center and is thinner). Height is defined before suppression with constructed by lines.

Draw a crossbeam between legs and show legs in volume.

We draw two distant legs of a table, they are more closely to each other, already and above lobbies.